7
tracking force. High frequency vibrations on a light-tracking cartridge can cause more
damage to the grooves of a record than running a cartridge at a heavy setting.
3. To adjust the arm height, loosen the setscrews on the base of the arm assembly and
turn the adjustment wheel above the base. Put a record on the platter and a 5X7 lined
index card (bent in half on the middle line) on the record near the spindle. Use the lines
on the card as a starting point to adjust arm height. Make the arm tube parallel to the
lines on the card. When the arm is at the desired height, tighten the screws. You can
raise or lower the arm later for fine adjustments.
Setting the Azimuth
1. Set a fireplace match or coffee stirrer (something light and about 6” long) into the
groove behind the mounting screws on the tonearm headshell.
2. If it is not level, use the supplied Allen wrench to loosen the setscrew on the
counterweight and rotate the counterweight around the shaft until the headshell is
parallel to the record. Be careful not to change the tracking force setting.
Playing Records
Before playing a record, make sure that all of the tonearm screws are tight.
1. Place the record on the platter then the record center weight. Carefully place the
periphery ring clamp down on the record keeping the clamp as level as possible. This
gives you the benefits of a vacuum without the problems or complications. Always turn
off the turntable before installing the periphery ring clamp.
2. Press the power button on the motor. Sit down and enjoy listening to your records!
General Use
• The Signature version of the JMW-9 has the ability to use damping fluid around the
pivot. Use this option sparingly and only if needed.
• When changing the speed of the turntable simple push the speed button on the SDS.
• Allow at least 20 hours of break-in time.
• The motors will make some low-level noise. This will not get into the system. The motor
and bearings will become quieter as you use your SSM.
• If you notice hum in the system, remove your interconnects and replace them with very
cheap, standard VCR interconnects. These are well shielded and should eliminate the
hum. If the hum goes away, get quality, well shielded interconnects.
• After at least one year of use, the platter bearing and motor will need to be lubricated.
For the platter and flywheel bearing, use 1/4 teaspoon of white lithium grease placed on
the ball. For the motor, use 1 drop of 40-weight motor oil below the brass piece.
Additional Items Available from Your Dealer
The TNT stand and HR-X top plate for the stand are available and give the best possible
sound from your SuperScoutmaster Signature. Check the website Gallery for pictures.
(7 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales